Follow

Castle Creations ESC Settings

The following settings are used by Hoverfly when using Castle Creations Phoenix ESCs

The Settings file which can be cut and pasted from the below text or you can use the attached file.

 

Warning:  Hoverfly Technologies, Inc. is providing this information as a suggested setting only.  Consult the ESC manual and make your own choices as to how to properly configure your product.

 

Cut after this line --------------------------------------------------------------------------

#######################################################
# Castle Link Data File
# Created: Friday, July 27, 2012
# Do Not Edit This File By Hand
#######################################################
Hex55: 85
Brake Delay: .6 sec (Delayed) (*)
Brake Ramp: Immediate (*)
Motor Start Power: 100
Direction: Reverse
Current Limiting: Normal (70A) (*)
Brake Strength: 0
BEC Voltage: 5
Power-On Beep: Enabled (*)
Motor Timing: 5
Data Log Enabled: 255
Vehicle Type: Multi-Rotor
Throttle Type: Fixed-Endpoints
Throttle Response: 5
Governor Gain: 15
Initial Spool-Up Rate: 5
Head Speed Change Rate: 5
Auto Rotate Enabled: False
Governor Mode Type: Simple
Cutoff Voltage: 40
Auto-Lipo Volts/Cell: 3.2 Volts/Cell (*)
PWM Rate: Outrunner Mode
Sample Frequency: 1 Sample / Sec (*)
Voltage Cutoff Type: Soft Cutoff (*)
Current Cutoff Type: Soft Cutoff (*)
Link Live Enable: Disabled (*)

 

End Cut before this line ----------------------------------------

 

CCPage1.png

CCPage2.png

CCPage3.png

 

Cutoff Voltage is set intentionally very low.  Use a Lipo alarm or Telemetry for Battery Pack voltage rather than have the ESCs cutoff power.

 

CCPage4.png

CCPage6.png

Was this article helpful?
1 out of 1 found this helpful
Have more questions? Submit a request

0 Comments

Article is closed for comments.
Powered by Zendesk